Dapoo Technology(Dongguan)Co.,Ltd
Contact person: manager Huang 13580920089
Tel: 0769-82681221
Fax: 0769-81162640
Business department 1: Huang Juan 15999819689
Business department 2: Wang Tingying 15999819619
Job QQ: 1659252710
website: www.dapootech.com
Email: hty8899@dapootech.com
Address: second floor, 72 Dongbao Road, Houjie Town, Dongguan City
#Acl-395 surface resistance tester
Parameters:
Power supply: 9 V PP3 alkaline battery
Measuring voltage: 9 V
Temperature range: operating temperature 5 ℃ to 49 ℃
Storage temperature: - 15 ℃ to 60 ℃
Relative humidity: 0% to 90% (non dewing state)
Measurement: the order of 10
Transition point: 1 / 2 order logarithm (3.16 × 10N)
Conversion point accuracy: ± 1 / 2 level
Accuracy: ± 10%
Repeatability: ± 5%
Weight: 170 g
Dimensions: 130 × 70 × 25 (mm units)
Calibration procedure of acl-395 surface impedance meter
Acl-395 meter adopts 1% ultra thin film resistance and high-speed amplifier circuit, and its calibration procedure is based on the linear circuit technology of the product.
The conversion point of impedance value is 1 / 2 logarithm, i.e. 3.16 × 10N. The linear value of conversion point is ± 10% of the mean value per unit of each measurement.
Measuring instrument: decade resistance box, test electrode
The resistance of the resistance box needs to be 1 × 103 ohm to 999 × 106 megohm or 109. When measuring the resistance value greater than 109, CAD generated technologies are used, because it is difficult to verify the resistance with impedance value greater than 999 × 106 by using 9 V voltage drive.
Connect the two electrodes of the resistance box to the two parallel electrodes of acl-395, adjust the resistance to 1K position, the 103 LED of the meter should be on, and the calibration of other gears should follow the same principle. When measuring the impedance conversion point, press the switch and continuously adjust the impedance value of the impedance bridge, and observe the impedance value when the next LED lamp is normally on (the value at this time is the conversion impedance value).
#It can be equipped with test weight, which is an optional accessory.